If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Does anyone have a tailwheel fender lying around?
I want to upgrade my tailskid to a pneumatic tailwheel, but don't seem
to find the tailwheel fender (housing) for it. Does anyone have one lying around (used or new)? Alternatively if someone out there has a mold for a 200x50 fender, I would love to borrow the mold and pull a fender out of it. Thanks, Morteza |
#2
|
|||
|
|||
Does anyone have a tailwheel fender lying around?
On Nov 17, 1:46*am, Morteza Ansari wrote:
I want to upgrade my tailskid to a pneumatic tailwheel, but don't seem to find the tailwheel fender (housing) for it. Does anyone have one lying around (used or new)? Alternatively if someone out there has a mold for a 200x50 fender, I would love to borrow the mold and pull a fender out of it. Thanks, Morteza I have molds for a fender and a fairing. Feel free to contact me off- forum. Thanks, Bob K. |
#3
|
|||
|
|||
Does anyone have a tailwheel fender lying around?
On Nov 17, 4:46*am, Morteza Ansari wrote:
I want to upgrade my tailskid to a pneumatic tailwheel, but don't seem to find the tailwheel fender (housing) for it. Does anyone have one lying around (used or new)? Alternatively if someone out there has a mold for a 200x50 fender, I would love to borrow the mold and pull a fender out of it. Thanks, Morteza W&W had one! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cobra Trailer fender needed! | [email protected] | Soaring | 1 | April 28th 08 01:56 PM |
wanted scott 3200 tailwheel /alaskan bushwheel tailwheel | phillip9 | Aviation Marketplace | 0 | June 6th 06 07:57 PM |
what is a fender washer? | [email protected] | Home Built | 46 | January 12th 05 06:07 PM |
Expensive fender bender | Bob Chilcoat | Piloting | 18 | February 20th 04 01:30 PM |
Plastic fender? | Steve Thomas | Home Built | 0 | August 28th 03 04:36 PM |