|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#16
November 30th 03, 07:26 AM
|
|||
|
|||
Tom!
Are you suggesting hiring labour overseas just so that you can pay them below the regular rate? I'm sure your local labour market would just love you to import some Eastern Europeans for 2 months to refinish your capitalist, elitist toy at a quarter the price of a locally quoted job. On that basis I'm sure there are several million people worldwide prepared to pack their bags and leave for Ellis Island tomorrow. Hell, I might even be one of them! I can just see it now, factory workers all over the USA down tools and riot in the streets just because of a bit of Gelcoat! :-) Ian "Tom Seim" wrote in message om... This may be totally off the wall, but has anyone thought about bringing the worker to the glider, rather than vice versa? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Refinishing radio stack front panels | Roger Halstead | Home Built | 2 | September 15th 04 04:20 PM |
| Older glass glider refinishing question | Gus Rasch | Soaring | 6 | November 10th 03 12:18 AM |
| Refinishing gelcoat | tango4 | Soaring | 21 | November 3rd 03 07:29 AM |
| Refinishing Your Aircraft (now in Oregon) | aerocomposites | Home Built | 0 | September 24th 03 05:29 AM |
Threaded Mode