|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
#11
October 14th 06, 05:09 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Brass or copper sheet?
Scott wrote:
For one of my different hobbies...does anybody have a good source for brass or copper sheet? I'm thinking something around 0.025" or 0.032" and two pieces that are about 30" X 30" or so each. Would I need to take out a second mortgage to obtain pieces like that? Scott Try a hobby shop at the mall. I just bought some .025 brass to make ground blocks. 
|
|
#12
October 15th 06, 02:20 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Brass or copper sheet?
Typically, roofing copper is 0.0216" thick (also known as 16 ounce
copper, as it weighs one pound per square foot) GeorgeB wrote: First place I'd try for copper is a roofer; they use it for flashing. I'm not sure about the thickness. On Fri, 13 Oct 2006 11:13:09 +0000, Scott wrote: For one of my different hobbies...does anybody have a good source for brass or copper sheet? I'm thinking something around 0.025" or 0.032" and two pieces that are about 30" X 30" or so each. Would I need to take out a second mortgage to obtain pieces like that? Scott
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Copper in oil analysis ? | [email protected] | Owning | 8 | August 22nd 06 12:31 PM |
| Copper in oil analysis ? | [email protected] | Instrument Flight Rules | 8 | August 22nd 06 12:31 PM |
| FS: 1930's Space Exploration Un-Cut Tatoo Sheet | J.R. Sinclair | Aviation Marketplace | 0 | June 7th 04 06:28 AM |
Linear Mode
