If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
PC power using aircraft ground
I run a Motion LS800 for my EFB. I use a DC 12V to 19V power
converter to power my LS800 since I have a 12V aircraft system. To minimize the number of wires, can I use a single wire to run +19V from the power converter to LS800 and connect the ground from power converter to LS800 thru the airfram ground? Thanks in advance, Robin Hou |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: 60' Aircraft ground power cable, 6-conductor, copper - $480 | [email protected] | Aviation Marketplace | 0 | May 16th 06 01:55 AM |
Permit to use aircraft radio frequencies on ground | C. J. Clegg | General Aviation | 23 | January 20th 05 07:23 PM |
Permit to use aircraft radio frequencies on ground | C. J. Clegg | Restoration | 1 | January 1st 05 10:08 PM |
Predicting ground effects on induced power | Marc Shorten | Soaring | 0 | October 28th 03 11:18 AM |
NEEDED: Aircraft Ground Handling Information | Jarry Clausing | Products | 0 | August 9th 03 03:24 PM |