|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 24th 19, 10:01 PM
posted to rec.aviation.soaring
|
|||
|
|||
LS 3A Turbulator Tape
I am wondering if the installation of turbulator tape on the wings and/or horizontal and vertical stabilizer will improve the performance of my LS3A? If so, where should the tape be located on each surface?
Thanks, 9P 
|
|
#2
September 25th 19, 06:12 AM
posted to rec.aviation.soaring
|
|||
|
|||
|
LS 3A Turbulator Tape
If I recall correctly, the LS3's profile is a FX67. This profile doesn't develop a separartion bubble, so a turbulator would be useless.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbulator tape for a PIK 20 | Blake Seese 9V | Soaring | 3 | May 2nd 15 05:51 PM |
| Kestrel 19 turbulator tape | Lee Davidson | Soaring | 3 | July 10th 14 01:10 PM |
| Kestrel 19 turbulator tape | Lee Davidson | Soaring | 0 | July 9th 14 10:34 PM |
| TURBULATOR TAPE ON VENTUS B | Ventus B | Soaring | 5 | February 18th 04 08:27 PM |
| LS-4A Turbulator tape question | Joe Lacour | Soaring | 1 | October 25th 03 11:39 PM |
Linear Mode
