|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 26th 03, 08:21 AM
|
|||
|
|||
EGT installation
I have an EGT gauge and sensor arrangement that came out of a Jabiru.
I want to install it in my Sonerai. What distance from the Exhaust port should I drill the hole for the sensor probe? 
|
|
#2
August 27th 03, 01:30 AM
|
|||
|
|||
|
Generally, not further than 2" from the exhaust port.
Andre wrote: I have an EGT gauge and sensor arrangement that came out of a Jabiru. I want to install it in my Sonerai. What distance from the Exhaust port should I drill the hole for the sensor probe?
|
|
#3
August 27th 03, 01:32 AM
|
|||
|
|||
|
Hey, Andre, was the Dyno mount too complicated---It's only useful to compare
changes in carb, timing, different props, etc. Andre wrote: I have an EGT gauge and sensor arrangement that came out of a Jabiru. I want to install it in my Sonerai. What distance from the Exhaust port should I drill the hole for the sensor probe?
|
|
#4
August 27th 03, 07:33 AM
|
|||
|
|||
|
Hey Jerry, I'm still in the planning stages.
I'm busy constructing my engine mount for my engine overhaul and my plan is to modify this engine mount with the necessary bearings etc. so that it serves the dual purpose as my out of aircraft working engine stand as well as a Dyno to see the effects of my efforts. "Jerry Wass" wrote in message ... Hey, Andre, was the Dyno mount too complicated---It's only useful to compare changes in carb, timing, different props, etc. Andre wrote: I have an EGT gauge and sensor arrangement that came out of a Jabiru. I want to install it in my Sonerai. What distance from the Exhaust port should I drill the hole for the sensor probe?
|
|
#5
August 27th 03, 08:33 AM
|
|||
|
|||
|
Thanx,
Is it possible to mount it too close? "Jerry Wass" wrote in message ... Generally, not further than 2" from the exhaust port. Andre wrote: I have an EGT gauge and sensor arrangement that came out of a Jabiru. I want to install it in my Sonerai. What distance from the Exhaust port should I drill the hole for the sensor probe?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
