If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
mismatched hole question
What would be a way to fix a mismatch in holes in steel without ruining the
temper? Specifically a main gear leg which it bolts up to a plate . Two of the four holes are about 1/3 diameter off. The bolts are 3/8" od. Possibilties, as I see it, a elongate existing holes in one part to fit the 3/8" bolts; drill new 3/8" holes in new location; install 1/4" bolts in mismatched holes. I don't have access to tooling or machinery that could drill out the holes to say 9/16", thereby replacing the 3/8 with bigger bolts. Any advice would be appreciated. Thanks, Dick |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 05:03 AM |
Question | Charles S | Home Built | 4 | April 5th 04 09:10 PM |
Legal question - Pilot liability and possible involvement with a crime | John | Piloting | 5 | November 20th 03 09:40 PM |
Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 01:26 AM |
T Tail question | Paul Austin | Military Aviation | 7 | September 23rd 03 06:05 PM |