If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Dittel 833 radio
Martin,
A few years ago I have downloaded a document about the RS232 serial interface of the KRT2 (it's from AirPlus, but I can't retrace the source). It says the data rate is 9600bd, 8 bit, no parity, no handshake. I will sent the document to you by e-mail. Okko Kloosterman Netherlands Op 21-3-2018 om 17:18 schreef Martin Gregorie: On Wed, 21 Mar 2018 11:58:26 +0000, John Wells wrote: I like mine, David -- it was comparatively good value for money. The UI isn't great (I can never remember which combination of buttons and twists does what, but that's a general gripe with most 57mm glider instruments these days). I can't use the .NET-based program Dittel supply to up/down load the preset frequency list because it won't run on Linux, so I'm writing my own program. I have a suitable wiring harness built and a specification of the protocol used for these uploads and downloads, but I don't know know the serial port settings on the radio. Can anybody tell me what baud rate, parity and stop bits setting the the KRT2 uses (pins 2,13 plus ground - same as it uses to talk to a remote head). |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
f/s Dittel FSG-71M radio | [email protected] | Soaring | 1 | June 4th 17 09:43 PM |
Dittel Fsg-5 radio | [email protected] | Soaring | 0 | July 21st 16 06:24 PM |
Used Dittel radio | Paul Natkiel | Soaring | 0 | March 2nd 09 07:17 PM |
Dittel Radio | [email protected] | Soaring | 11 | January 27th 09 09:09 PM |
Dittel Radio | Paul | Soaring | 0 | January 9th 06 11:50 PM |