If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Instrument CAD templates wanted.
Can't help you with CAD files but have you tried this virtual panel builder?
http://epanelbuilder.com/ Jerry Dave wrote: Hi all, I'm looking for a few accurate CAD templates for basic instruments. I'm also looking for a CAD panel template for a RV7. Thanks Dave |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
All I Wanted For Christmas Were Inverted Spins | [email protected] | Aerobatics | 3 | December 29th 04 07:40 PM |
Wanted an Alon | Joe Spencer | Home Built | 1 | September 1st 03 07:44 PM |
Vans RV4 or RV6 wanted | Joe | Home Built | 0 | August 17th 03 01:02 PM |
Murphy Rebel Wanted | Joe | Home Built | 0 | July 8th 03 06:21 AM |
Used Bing 54 Carbs wanted | Ed Baker | Home Built | 0 | July 4th 03 12:41 PM |