|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#31
February 8th 05, 07:55 PM
|
|||
|
|||
Yes. You can buy shims to adjust toe-in and camber.
"Jay Honeck" wrote in message news  c4Od.56466$EG1.37716@attbi_s53...Then again, could be that one wheel just needs alignment. G You know, I was wondering about that. Can a fixed landing gear be "cocked" to one side or the other? That would wear a tire out in no time. (Although it wouldn't explain flat-spotting...) -- Jay Honeck Iowa City, IA Pathfinder N56993 www.AlexisParkInn.com "Your Aviation Destination" 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lyc. O-360 cylinder question | JB | Owning | 13 | November 27th 04 09:32 PM |
| Speech: A Question of Loyalty: Gen. Billy Mitchell | Otis Willie | Military Aviation | 0 | September 25th 04 09:30 PM |
| Handheld battery question | RobsSanta | General Aviation | 8 | September 19th 04 03:07 PM |
| VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 05:03 AM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 01:26 AM |
Linear Mode
