|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 9th 04, 09:32 PM
|
|||
|
|||
Photos of damage to J3 Cub propeller after new engine mount installation
Photos of damage to J3 Cub propeller after replacement of old engine
mount with new factory engine mount. Cowl clips rub against back of propeller, wearing a groove the size of a nickel and a few centimeters deep in the metal prop. Worth checking your installation for similar problem. Note the cowl clips lie flat against the cowl during preflight and appear to rotate 90 degrees to strike prop only when engine is running. Photos show clips in rotated position. a href="http://www.geocities.com/jruh/"link to photos/a 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Photos of damage to J3 Cub propeller after new engine mount installation | [email protected] | Home Built | 0 | August 9th 04 09:31 PM |
| Propeller for aircraft engine ground test | Guy Deraspe | Home Built | 0 | July 21st 04 04:41 AM |
| Rec.Aviation "Rogue's Gallery" of aircraft photos update | Jay Honeck | Home Built | 8 | May 4th 04 05:01 AM |
| turbine propeller | sebastian | Home Built | 19 | March 21st 04 01:47 AM |
| MT. DIABLO HIGH SCHOOL CONCORD, CA PHOTOS | MT. DIABLO HIGH SCHOOL PHOTOS | Home Built | 1 | October 13th 03 03:35 AM |
Linear Mode
