|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 16th 20, 04:25 PM
posted to rec.aviation.soaring
|
|||
|
|||
Help needed with Flarm cable
Hi
I have installed LX8000 1st gen in our glider. I am trying to use a Nano3 as Flarmdisplay, and looking for advice on the connection. I have the Nanopower connected to 12v, and USB cable to the Nano3. Next i need a cable from the LX8000 alarm display to the Nanopower RJ45. This is where I am stuck. The RJ45 on the Nanopower is not IGC std. Does anyone know which wires to connect to which pins? Thanks! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Needed: Good (cheap) source for SS cable & sweges | wright1902glider | Home Built | 11 | August 19th 07 04:03 AM |
| Prop Cable Needed | zatatime | General Aviation | 2 | May 10th 04 10:30 PM |
| Prop Cable - Replacement Needed | zatatime | Owning | 0 | May 7th 04 04:37 PM |
| Cable parts needed in Dallas | dave | Home Built | 4 | October 23rd 03 04:12 AM |
| Cable parts needed in Dallas | dave | General Aviation | 4 | October 23rd 03 04:12 AM |
Threaded Mode