If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
Ventus b flap sealing
On Wednesday, March 31, 2021 at 2:20:57 PM UTC-5, wrote:
On 3/31/2021 2:32 AM, krasw wrote: Mylars do not seal the gap, to create airtight barrier you need that s-tape. Right, mylar+teflon helps but does not seal completely on these gliders. Its some decades back, but IIRC the rolling seal was an option, and did help with performance (but a maintenance nuisance). If you're working on seals anyway, consider adding the rolling seal if not already equipped... Hope that helps, Best Regards, Dave Thanks for the input Dave, I'm not sure the rolling seal is worth the effort and expense. I'm not that good to know the difference : ) I might have to remove the flap and inner aileron to fix an issue with play in the actuating rod at the aileron connection, but that's a different story. Dick Johnson's Ventus A review mentions factory seals along the hinge line, but he didn't mention the rolling seal that is evident in the aft wing root photo in the article. The flap to fuselage junction has mylar also, which mine is lacking, although it does have rubber boots inside the fuselage on the flap actuating tube. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
S-H Ventus light-bar flap position indicator | [email protected] | Soaring | 16 | March 24th 16 11:41 PM |
Ventus C (1986) - Flap and Gear Indicator | Ken Kochanski (KK) | Soaring | 3 | January 19th 10 01:33 PM |
Sealing The PIK-20B Canopy | P. Corbett | Soaring | 5 | August 21st 05 08:32 PM |
Sealing a Schweizer; 1-35 mainly | TOM RENT | Soaring | 0 | April 11th 04 08:46 PM |
Libelle Gap Sealing | Owain Walters | Soaring | 4 | April 11th 04 07:13 PM |