|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
July 21st 03, 09:57 PM
|
|||
|
|||
MikeM wrote:
Chad Lemmen wrote: MikeM wrote: Did this ever work right, or is it a problem that just cropped up? It's a new problem. The only thing that was done recently was the installation of UMA light wedges. I also pulled the breaker on these though and the problem didn't go away. Not familiar with UMA light wedges. Are they flourescent/electroluminescent, as opposed to incandescent or LEDs? They are electroluminescent, but since I get the noise even with the breaker pulled for these lights I don't think they are what is causing it. Maybe this sound has always been there, but I don't think so or at least I just noticed it. I can also hear the retractable landing lights in the headsets when the lights are either extending or retracting. This is also something I never noticed before. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ADF static? question | JFLEISC | Home Built | 3 | December 28th 04 01:28 AM |
| Is my static port leaking? | Derrick Early | Instrument Flight Rules | 2 | August 15th 04 01:13 AM |
| FS: Avery Dennison Adds Static Cling Vinyls to Fasson® Rapid-Roll Dry erase easel pads that clings to most walls. | M.Roy | Home Built | 0 | February 11th 04 05:18 PM |
| Is a static port a precision thing? | Larry Smith | Home Built | 8 | August 12th 03 10:26 PM |
| Canard static port location | Paul Lee | Home Built | 1 | July 12th 03 02:55 AM |
Threaded Mode