|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 3rd 05, 07:54 PM
|
|||
|
|||
water wing tank venting
Has anybody experience with central venting like an ASW 24 but with a hard
tank. I am preparing the internals of the wings and I would like to vent three tanks in on wing independently and join the three vents lines at a manifold at the root rip and then with a single line up to the deck. Comments please. Regards Udo 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Water Cooled Jet Engines: a possibillity then and now? | The Enlightenment | Military Aviation | 3 | December 18th 03 09:41 AM |
| ASW27 Wing water tank | Ray Gimmey | Soaring | 0 | November 10th 03 10:35 PM |
| Yo! Fuel Tank! | Veeduber | Home Built | 15 | October 25th 03 02:57 AM |
| Props and Wing Warping... was soaring vs. flaping | Wright1902Glider | Home Built | 0 | September 29th 03 03:40 PM |
| #1 Jet of World War II | Christopher | Military Aviation | 203 | September 1st 03 03:04 AM |
Threaded Mode