If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Polyurethane finish?
I recently purchased a glider which was refinished
in polyurethane and I'm wondering what is the best way to look after the finish? Should I put something like wxblock on it or just use a good automotive wax? should it be hard waxed and buffed like gel coat? What about fixing any problem areas? Is sanding a good idea? Any advice would be appreciated. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Blistering of Finish | Uniform Zulu | Soaring | 10 | December 24th 07 04:40 PM |
Quickie / Rutan plans with polyurethane foam | [email protected] | Home Built | 3 | March 28th 06 01:04 AM |
Finish lines | Thomas Knauff | Soaring | 72 | May 24th 05 06:09 AM |
Taking care of my Jantar polyurethane | Miguel Lavalle | Soaring | 1 | February 18th 04 02:41 PM |
Best Polyurethane Paint for Homebuilt | jls | Home Built | 2 | February 8th 04 01:25 AM |