|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 2nd 07, 03:10 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
What would you call this tool? Bolt drill guide?
Some years ago, I watched an A&P drill a shank so it would accept a
cotter pin. Was a metal block into which various sized bolt could be screwn into, each with a hole perpendicular to the shaft that would guide a drill bit. Anyone know what this might be called? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Call for opinions on new XC planning tool | Matt Herron Jr. | Soaring | 3 | September 29th 06 06:38 AM |
| Reamed out by Approach | Bob Chilcoat | Piloting | 26 | March 29th 05 12:32 AM |
| Naval Aviators | jsmith | Piloting | 1 | March 25th 04 02:56 PM |
| Papco #600 -- Roto-Master Flaring Tool | Michael Burton | Aviation Marketplace | 0 | October 27th 03 05:35 PM |
| FS: Papco #600 Flaring Tool | Michael Burton | Home Built | 0 | October 27th 03 05:26 PM |
Threaded Mode