|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 10th 05, 02:03 AM
|
|||
|
|||
How did he make this joint?
At http://members.cox.net/mhorowit/interesting weld with comment.jpg is a pic of two tubes welded at 90 degrees. Any idea how he got any strength to the joint? I don't think either tube had any metal removed for fitting. - Mike 
|
|
#2
September 10th 05, 02:07 AM
|
|||
|
|||
|
Sorry, wrong NG - MIke
Michael Horowitz wrote: At http://members.cox.net/mhorowit/interesting weld with comment.jpg is a pic of two tubes welded at 90 degrees. Any idea how he got any strength to the joint? I don't think either tube had any metal removed for fitting. - Mike
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Showstoppers (long, but interesting questions raised) | Anonymous Spamless | Military Aviation | 0 | April 21st 04 05:09 AM |
Linear Mode
