If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Machine shop information needed.
I have a friend with a Ercoupe whose steering knuckle/assembly has been
worn to where it is too sloppy. It's about 2.20 inches in diameter and rotates on the nose strut assy. It's what the scissors are attach to. It either needs to be bushed or trued up and add a bearing sleeve to the mating surface. Are there any machine shops in the DFW area that can do this kind of work for a decent price? Thanks Dave |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Machine shop information needed. | Dave[_16_] | Owning | 8 | October 14th 07 04:16 AM |
deHavilland Devon VP 979 Information needed | [email protected] | General Aviation | 0 | July 8th 06 01:29 PM |
Pirep needed for Gulf Shores (JKA) Paint Shop | David | Owning | 0 | July 1st 04 02:12 PM |
CH/MH-53E information needed - Maintainers? | Sherman C | Rotorcraft | 0 | June 27th 04 02:17 AM |
NEEDED: Aircraft Ground Handling Information | Jarry Clausing | Products | 0 | August 9th 03 03:24 PM |