|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 23rd 06, 03:54 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
arplast prop
I am trying to help a widow with a Europa . Her husband before he died of
natural causes sent his Arplast 3 bladed prop off to New Zealand to be refurbished. It has come back. As they ship it without the blades attached, I have to do this. Can some one tell me or direct me to a source or manual for this prop? I need to know torque values for tightening the hub rings. -- Cy Galley - Chair, AirVenture Emergency Aircraft Repair A Service Project of Chapter 75 EAA Safety Programs Editor - TC EAA Sport Pilot 
|
|
#2
April 23rd 06, 10:20 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
arplast prop
Cy Galley wrote: I am trying to help a widow with a Europa . Her husband before he died of natural causes sent his Arplast 3 bladed prop off to New Zealand to be refurbished. It has come back. As they ship it without the blades attached, I have to do this. Can some one tell me or direct me to a source or manual for this prop? I need to know torque values for tightening the hub rings. -- Cy Galley - Chair, AirVenture Emergency Aircraft Repair A Service Project of Chapter 75 EAA Safety Programs Editor - TC EAA Sport Pilot All I've found so far, Cy... http://www.bmaa.org/upload/techdocs/...ns%20index.pdf
|
|
#3
April 23rd 06, 10:23 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
arplast prop
|
|
#4
April 24th 06, 12:38 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
arplast prop
Cy Galley a écrit :
.... sent his Arplast 3 bladed prop off to New Zealand to be refurbished. It has come back. As they ship it without the blades attached, I have to do this. Can some one tell me or direct me to a source or manual for this prop? I need to know torque values for tightening the hub rings. Cy, You might want to see the manufacturer's website http://pro.wanadoo.fr/arplast/ Arplast is located in France. If you give me information about the prop, I can call them and ask. Regards, Gilles Thesee Grenoble, France http://contrails.free.fr
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Why does a prop ice up so apparently readily? | Mike Rapoport | General Aviation | 3 | November 8th 05 02:52 PM |
| Why does a prop ice up so apparently readily? | Mike Rapoport | Piloting | 2 | November 8th 05 02:52 PM |
| Why does a prop ice up so apparently readily? | Mike Rapoport | Instrument Flight Rules | 2 | November 8th 05 02:52 PM |
| Ivo Prop on O-320 | Dave S | Home Built | 14 | October 15th 04 03:04 AM |
| IVO props... comments.. | Dave S | Home Built | 16 | December 6th 03 11:43 PM |
Linear Mode
