If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Q about trailer wheel bearings
I just pulled off the wheels to replace the tires (cracked side walls),
and I'm wondering about the wheel bearings. I see a grease gun fitting threaded into a cup, which is captured by a 'C' ring. The grease gun fitting looks pretty rusty itself. Should I replace the zerk and pump in new grease, or should I take the whole cup out, flush out the old grease, put the cup back in with a new grease gun fitting and start fresh? Anything else I should look at while I'm in there? Ken |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Eberle trailer wheel rims | Bob | Soaring | 7 | November 25th 11 05:39 PM |
K21 brake parts | Stuart Kinnear | Soaring | 10 | June 26th 06 09:54 PM |
BGA Tech. News, Wheel brakes. | W.J. \(Bill\) Dean \(U.K.\). | Soaring | 8 | May 31st 05 01:55 PM |
US source for wheel on the tongue of Cobra trailer? | Mark Zivley | Soaring | 3 | January 18th 05 03:51 AM |
E2-C wheel bearings needed | CaptAro | Restoration | 1 | July 19th 03 04:32 AM |