Next time you do it, try brass-grommeting the material and using black ("UV
resistant") plastic tie-wraps to hold material to frame. It is a LOT easier
than using hogring pliers.

Jim



"Mike Spera" wrote in message
ink.net...
Day 48 (The Seats)

I hog
ringed the bottom of the seat backs shut. The rings can only be seen when
you look over the back of the rear seats. If I had a baggage area, I
probably would not have offset the rings as much towards the back, but
would have tried harder to get them exactly at the bottom where they could
not be seen from either direction. In reality, once the rears are
installed, the bottoms snug up against the backs in a way that you could
probably even put the seam towards the front a little and still not see
them.