|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 19th 03, 01:34 AM
|
|||
|
|||
PT6 question
Why do we pull the props back to feather prior to shutting down? I cannot see
any reason for this. This seems a useless procedure on the shutdown checklist. If the prop levers are left forward upon shutdown, the prop blades will go into feather when oil pressure drops off. On start up, the props will unfeather with the same spool up as if the check list was followed. Thx in advance, VL 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lyc. O-360 cylinder question | JB | Owning | 13 | November 27th 04 10:32 PM |
| VOR/DME Approach Question | Chip Jones | Instrument Flight Rules | 47 | August 29th 04 06:03 AM |
| Question | Charles S | Home Built | 4 | April 5th 04 10:10 PM |
| Legal question - Pilot liability and possible involvement with a crime | John | Piloting | 5 | November 20th 03 10:40 PM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 02:26 AM |
Threaded Mode