|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 14th 06, 04:41 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Tech: Aluminum Forming Question
Can anyone tell me how to form the internally rolled edge on the turtledeck
access panel seen here? http://www.steenaero.com/Files/Proje...01385_main.jpg Thanks! Scott 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 24/7 computer tech support | [email protected] | Home Built | 0 | May 5th 04 04:32 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 04:52 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 07:24 AM |
| A Source for Aluminum | Ron Wanttaja | Home Built | 4 | October 11th 03 02:38 AM |
| Duo Discus Tech note | Thomas Knauff | Soaring | 25 | August 9th 03 11:10 PM |
Threaded Mode