|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#8
February 27th 15, 04:11 AM
posted to rec.aviation.soaring
|
|||
|
|||
CNC Waterjet cutting instrument holes
On Thursday, February 26, 2015 at 1:09:53 PM UTC-8, wrote:
...7725 bid cloth that I had lying around (a decent cloth, but surely not what Schempp Hirth used)... I have yet to find anybody who, when presented with unlabeled samples of Hexcell 7725 and Interglas 92125, can tell them apart. As for the instrument panel cutouts, I am firmly in the holesaw camp--the carbide grit blades are great for that. I get a fair bit of stuff waterjet and laser cut, but only where it is the most cost- or time-effective method. For a round cutout and four screw holes, a good holesaw plus a template from the Schreder library makes it a five-minute job. Thanks, Bob K. https://www.facebook.com/pages/HP-24...t/200931354951 Thanks, Bob K. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trying to fill some holes in the instrument panel | [email protected] | Soaring | 2 | February 12th 14 03:55 AM |
| Cutting 57mm holes in the instrument panel.....how to? | John Bojack[_2_] | Soaring | 20 | November 12th 10 10:15 PM |
| When Poorboys drill holes ...was: Drilling holes in steel tubing | wright1902glider | Home Built | 4 | November 4th 05 02:19 AM |
| Cutting shirttails??? | Larry Dighera | Soaring | 11 | September 3rd 03 04:34 PM |
Threaded Mode