|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 24th 16, 03:26 AM
posted to rec.aviation.soaring
|
|||
|
|||
SN10b and Flarm core
Has anyone out there ever used the Flarm-core's GPS-out signal coming from the 9pin subD plug to pipe it into an SN10b? If so, what kind of a connector did you use?
I just don't want to run yet another GPS-engine if the signal is available already but not used. Thanks, Uli 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Information for all users of Flarm, OEM FLARM supplier and Flarm PowerFlarm | [email protected] | Soaring | 28 | March 12th 16 05:31 AM |
| Mux, 302, Flarm Core, Dell Streak | Blake Seese 9V | Soaring | 5 | April 27th 15 04:06 PM |
| PowerFLARM Core secondary FLARM antenna | [email protected] | Soaring | 27 | October 7th 14 02:53 PM |
| FLARM Core weight | [email protected] | Soaring | 6 | May 11th 13 08:21 PM |
| Cabeling of ILEC SN10B with Flarm | mkaiser | Soaring | 4 | July 12th 10 05:04 PM |
Threaded Mode