PDA

View Full Version : re: mounting a PCAS on the glareshield


Mike Noel
October 1st 08, 04:49 PM
Geoff, thanks. Nice idea.


Ez

Step 1) get a chunk of 1/8 lexan from the local hardware store - have them
cut it to, oh, about 6 inches by10 inches or so.

Step 2) send the wife to visit her mom for the afternoon (important - do
this before step 3)

Step 3) put the lexan in the oven for a couple hours at about 180 F. to
drive off the water - then raise the temp. to about 250 or 300 wait for it
to get rubbery

Step 4) wrap the lexan around a chunk of 1x6.

You will now have a platform that is about 6 inches by about 5 3/4 inches
wide with two "feet" that will straddle the hump on the glare shield. If it
has a strong compound curve, you will have to cut away the middle of each
side to make 4 individual feet (or make adjustments with a heat gun).

Stick the lexan to the PCAS with double side tape and put the velcro on the
feet.

A custom mount with no muss, no fuss (unless your wife catches you putting
the lexan in her oven)...

--
Geoff
The Sea Hawk at Wow Way d0t Com
remove spaces and make the obvious substitutions to reply by mail
When immigration is outlawed, only outlaws will immigrate.

--
Best Regards,
Mike.

http://flickr.com/photos/mikenoel/

http://photoshow.comcast.net/mikenoel

Google