A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Home Built Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Mixed Gases Stratify? by jls
Let's say you mix 1 part avgas with 3 parts mogas for use in your flying O-300-powered demon. You have an STC for doing this, of course. These two fuels have different specific gravities, so it is said. Do they stratify? I don't believe they do. Anybody have a comment? I guess you could...
September 30th 04 05:58 AM
by Jerry J. Wass Go to last post
2 495
Fuel Lines & thread compound by Evan Carew
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Can you use TFE paste on fuel line threads (the little blue fittings which are NPT on one side & 32 deg on the other)? If not, what is reccomended? Thanks, Evan
September 30th 04 05:28 AM
by Del Rawlins Go to last post
1 1,525
Sources for DIY avionics??? by Netgeek
MANY years ago I built up quite a few kits that I got from RST (thanks to Jim Weir!) and really enjoyed it while learning alot. But that was more than 20 years ago. In looking around lately I can find very little that would be suitable for DIY. As a product designer for the last 25 years I...
September 30th 04 12:51 AM
by Netgeek Go to last post
7 3,468
AA NiMH Best Deal by Jim Weir
The NiMH AA batteries in the handheld are now almost 6 years old, and are starting to show their age. What's the best deal going on AA batteries these days? Jim Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com ...
September 29th 04 08:39 PM
by Barnyard BOb - Go to last post
27 1,910
Boeing 747 Simulator plans - help? by Nippoo
I'm planning on building a Boeing 747 simulator (a physical one which you can get inside!). I've found these plans for the overhead panel: http://www.glideslope.de/images/LH744_overhead.gif but I can't find anything similar for the other panels. Help!
September 29th 04 05:19 PM
by Nippoo Go to last post
9 2,190
Need recomendations for buying a welding /brazing torch... by Wright1902Glider
Hello everyone, Just stepped in from the shop for a few moments. I need a recomendation and/or input (based on actual experience please) regarding a BurnzOMatic Oxy/MAPP gas torch. That's the one on the Home Depot shelf that uses two small cylinders and sells for about $50. Has anyone ever used...
September 29th 04 03:31 PM
by Wright1902Glider Go to last post
9 979
Motorglider at Copperstate fly-in by Robertmudd1u
The Pipistrel Sinus motorglider will be at the Copperstate fly-in. I should be in space A5 right on the flight line. This all composite aircraft is available as a kit. And yes, I know it is a funny name. Visit www.pipistrel-usa.com for more information. Robert Mudd Pipistrel-USA
September 29th 04 11:45 AM
by Robertmudd1u Go to last post
0 928
Lycoming throttle linkages by Evan Carew
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Anyone have pictures of their throttle linkages for a lycoming engine (O-235)? Thanks, Evan -----BEGIN PGP SIGNATURE-----
September 29th 04 01:58 AM
by Evan Carew Go to last post
0 1,103
TriMotor Crash by log
Was it the EAA Trimotor that crashed yesterday in the Merced(sp) Flyin???
September 28th 04 07:53 PM
by Rich S. Go to last post
8 928
Elementis 3243 Epoxy? by Corrie
Wondering if anyone has used this. A local industrial supply house recommended it when I asked about T-88, which they didn't carry. (Yes, I know I can get T-88 from AS or Wicks) It was failry inexpensive so I picked up a half-gallon, and I plan to do some tests. According to the specs sheet it has...
September 28th 04 03:45 PM
by Corrie Go to last post
0 384
Cirrus Deploys Chute Safely by m alexander
http://www.modbee.com/local/story/9180849p-10080739c.html
September 28th 04 12:09 AM
by Byron J. Covey Go to last post
40 2,665
HomeBuilt English Wheel by BillC85
To All, Built this in my shop yesterday. http://www.roddingroundtable.com/tech/articles/12ewheel.html Total parts cost was right about $47.00 and total time to build was eight hours. I deviated a little from the plans because I didn't have some of the stuff laying around (the telescoping...
September 27th 04 07:36 AM
by Del Rawlins Go to last post
2 1,891
Weight by LJ & Nancy Blodgett
what's the process to change the up weight on a Kitfox 7 to the Sport weight of 1320#.Thanks LJ
September 27th 04 06:19 AM
by StellaStar Go to last post
23 1,922
Air/Oil separator Best one for $ by Ron
Aircraft Spruce (and others) sell a variety of air/oil separators. The Walker (Airwolf) being the most expensive and a homemade the least costly. Any recommendations and/or comments as to the effectiveness vs. cost vs. brand. For experimental airplane so TSO is of no consequence. Lycoming IO 320...
September 27th 04 12:10 AM
by Rip Go to last post
1 1,224
Noisy Radio by Justin H
following up on a previous post. I have a GPSCOM 190 Handheld radio under its own power, I think its getting interference off the P-Leads. How can I ground this out. I only hear it when I PTT. recieve is beautiful.
September 26th 04 03:52 PM
by Justin H Go to last post
0 898
Sirius Aviation? Recent Experiences? by Carlos Reyes
I saw that Sirius Aviation (www.sirius-aviation.com) had trouble fulfilling orders 2-3 years ago. Can anybody comment on the current situation? Has anybody purchased spruce from them recently? I'm having trouble getting in touch with them (phone and e-mail), and I'm not sure what to make of...
September 25th 04 08:43 PM
by Jim Stockton Go to last post
6 1,632
Fuel Injection by Justin H
I have an O290-D with a Lake Injector carb, if anyone knows what that is. Im not to happy with it for a number of reasons, can anyone make some good alternative recommendations. Can it be made into fuel injection?
September 25th 04 04:26 PM
by Jerry J. Wass Go to last post
2 1,307
Hangar for rent. KMMV Oregon by broadmead
Just wanted everybody to know that I have a 40' x 30'+- "T" hangar for rent. It is at the Mcminnville Oregon airport and costs $250 per month. It is a new unit that includes basic electricity. Protect your baby from the upcoming winter; available now.. Contact John...
September 25th 04 12:47 PM
by NW_PILOT Go to last post
3 1,290
Aerobatic Engine question by Jay Moreland
I need to have someone explain to me the advantages of two different Aerobatic engines: IO-360 with Christen Inverted Oil system VS an AEIO-360. Are there any inherent benefits of one over the other when doing acro with negative G maneuvers? Or are they essentially the same? Can you take any...
September 25th 04 05:43 AM
by Jay Moreland Go to last post
0 691
Lost another homebuilder. by [email protected]
Larry Edwards (age 71) of the Kitchener area of Ontario was building a scratch-built Pegazair. He and his father (91 yrs old) went for a sail on Lake Ontario in their home-built 20 foot sail boat on Wednesday and did not return. "Speedy" will be missed by the RAA members who knew him
September 24th 04 06:10 PM
by [email protected] Go to last post
0 351
Post New Thread


Display Options
Showing threads 4501 to 4520 of 6903
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 03:58 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AviationBanter.
The comments are property of their posters.