![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I did not realize that if I replied to a cross-posted message my reply would
also be cross-posted. Cheeezz!! I'm Bob Gardner and I approved this message. |
#2
|
|||
|
|||
![]()
On Mon, 20 Sep 2004 12:50:19 -0700, "Bob Gardner"
wrote: I did not realize that if I replied to a cross-posted message my reply would also be cross-posted. Cheeezz!! I'm Bob Gardner and I approved this message. Depends upon your software. Some ask you if you want to reply to the original newsgroup only or all of them that it was posted to. Rich Russell |
#3
|
|||
|
|||
![]() "Bob Gardner" wrote: in message ... I did not realize that if I replied to a cross-posted message my reply would also be cross-posted. Cheeezz!! Don't feel too bad: I knew better and did it anyway. Doh! -- Dan C-172RG at BFM |
#4
|
|||
|
|||
![]()
Hey Bob,
Your many fine contributions (both on usenet and in print) entitle you to a few trivial missteps... |
#5
|
|||
|
|||
![]() "Bob Gardner" wrote in message ... I did not realize that if I replied to a cross-posted message my reply would also be cross-posted. Its just that nobody looks up to the headers when replying. The "to" newsgroups are entered automatically in most composers, and all you have to do is remember to look up there and remove the ones you don't want. |
#6
|
|||
|
|||
![]() "Bob Gardner" wrote in message ... I did not realize that if I replied to a cross-posted message my reply would also be cross-posted. Its just that nobody looks up at the headers, when replying. Most composers enter the newsgroups automatically and you have to remember to look up there and remove the ones you don't want. If your composer does not show the headers, there should be an option somewhere (like under the "view" menu item) which allows you to default so that all headers are always in view. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Another Addition to the Rec.Aviation Rogue's Gallery! | Jay Honeck | Home Built | 125 | February 1st 04 05:57 AM |