|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 18th 07, 03:55 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
brake reservoir installation
I want to use the ACS Model A-600 brake reservoir. It's the kind that
screws directly into the master cylinder port. Because of conflict with the pedals I'll have to put one on the right master cylinder on the pilot's side and one on the left master cylinder on the copilot's side. Will this setup pass inspection? Thanks 
|
|
#2
June 19th 07, 01:56 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
brake reservoir installation
Why shouldn't it!
All it has to do is work. -- Cy Galley - Chair, AirVenture Emergency Aircraft Repair A 46 Year Service Project of Chapter 75 EAA Safety Programs Editor - TC EAA Sport Pilot wrote in message oups.com... I want to use the ACS Model A-600 brake reservoir. It's the kind that screws directly into the master cylinder port. Because of conflict with the pedals I'll have to put one on the right master cylinder on the pilot's side and one on the left master cylinder on the copilot's side. Will this setup pass inspection? Thanks
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2-33 brake drum | [email protected] | Soaring | 2 | June 9th 07 02:22 AM |
| brake fittings | [email protected] | Home Built | 6 | April 30th 07 01:33 AM |
| ?? Mooney m20J brake fluid reservoir | Russ Haggerty | Owning | 4 | March 5th 07 05:27 PM |
| K21 brake parts | Stuart Kinnear | Soaring | 10 | June 26th 06 09:54 PM |
| looking for a 75 to 100 ton press brake about 8/10 ft | Adrian eyre | Home Built | 1 | January 6th 05 05:28 AM |
Linear Mode
