![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I have the above mentioned device, along with a 128 MB data card and
associated loader. Recently, I acquired some nice topographic maps of the region I fly in and was wandering: is it possible in any way, by using some program or similar, to transfer some of these maps into the 196 basemap format and use them instead of the default one, or possibly combine them to form a terrain map with associated aeronauticaly thingies? Since I'm a VFR flyer who spends most of his time down below 8000 ft, it would be a nice help. Also, I'm thinking of using it for ground navigation with the same map. Triple Delta |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
WTB: Garmin GPSMAP 196 ccessories | bobo | Aviation Marketplace | 0 | December 7th 04 04:07 AM |
Question on Garmin GNC 250XL | Ron | Home Built | 1 | October 24th 04 08:26 AM |
Garmin GPSmap 196 on 172 Yoke | Otto Braasch | Owning | 2 | February 20th 04 09:58 PM |
Garmin audio panel question | Brinks | Owning | 1 | September 10th 03 08:41 PM |
GARMIN 196 QUESTION | Cub Driver | Piloting | 5 | July 9th 03 04:29 PM |