|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 9th 13, 04:01 PM
posted to rec.aviation.soaring
|
|||
|
|||
Any Hints for servicing Tost Master Cylinder (Type 7)?
Specifically, is there an easy way to seat/move into the proper position the "Seal G" on the master piston?
I've lubricated with brake fluid, but had my first attempt result in a snapped/failed seal. Any experienced hints would be appreciated. Tim EY 
|
|
#2
July 17th 13, 09:12 AM
posted to rec.aviation.soaring
|
|||
|
|||
|
Any Hints for servicing Tost Master Cylinder (Type 7)?
On Wednesday, July 10, 2013 3:01:45 AM UTC+12, wrote:
Specifically, is there an easy way to seat/move into the proper position the "Seal G" on the master piston? I've lubricated with brake fluid, but had my first attempt result in a snapped/failed seal. Any experienced hints would be appreciated. Tim EY I found the very same problem with 2 seals supplied from Tost. It appears the seal in the kit is the incorrect size or old stock that is no longer supple enough to fit over the flange. Alan.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Master cylinder rebuild? | J. Murray | Soaring | 4 | September 28th 12 04:41 AM |
| www.soaringdata.info hints (US) | 2KA | Soaring | 0 | March 25th 11 04:43 PM |
| Grob 103 Twin II Brake Master Cylinder | Mike McCarron | Soaring | 28 | November 23rd 08 03:33 PM |
| ATC subtle hints | kontiki | Piloting | 76 | October 25th 06 01:13 AM |
| Need G-103 Acro Master Cylinder | Ray Lovinggood | Soaring | 5 | September 30th 03 03:39 AM |
Linear Mode
