|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 14th 16, 12:25 AM
posted to rec.aviation.soaring
|
|||
|
|||
Metric Spring Steel
Anyone know where I might find a small quantoty of 20 x 3mm spring steel to rebuild the tail spring on my Ka-6?
It suffered a hard landing and one of the leafs got buggered up pretty badly. All I can find at the usual sustpects (McMaster and Grainger) is mild 1008/10018 steel in that size. Thanks Peter 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Metric Instruments | Roy Bourgeois | Soaring | 29 | May 27th 13 01:53 PM |
| Metric Soaring | Paul Hanson | Soaring | 23 | September 20th 07 01:38 PM |
| VW engines by metric AP | [email protected] | Home Built | 15 | August 7th 07 03:48 PM |
| Metric Instruments? | AFSax | Soaring | 14 | August 24th 05 02:52 PM |
| Suitable coating for spring-steel wire? | Wright1902Glider | Home Built | 6 | February 9th 04 04:12 PM |
Threaded Mode