|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 18th 03, 05:39 PM
|
|||
|
|||
Carbon Spar design and construction workshop
The Marske Flying Wing Shop in Marion Ohio will conduct a Carbon Spar design and construction workshop for composite aircraft on November 22 and 23 ,2003. Those interested should email us immediately. Cost will be $250 Jim Marske over the last ten years has developed wing spars utliizing carbon rods as in his design of the Genesis which with stood over 18 G's before the fixture broke. This is a very good chance to see how a spar should be built and as well as having the tools to design the spar you will actually take part in making a spar. -- Marske Flying Wings http://www.continuo.com/marske 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Marske spar workshop oct 15-16, 2004 | mat Redsell | Restoration | 0 | August 24th 04 04:32 PM |
| Marske spar workshop | Marske Flying Wings | Restoration | 0 | October 14th 03 04:54 PM |
| Marske spar workshop | Marske Flying Wings | Home Built | 0 | October 14th 03 04:53 PM |
| Carbon Spar design and construction workshop | Marske Flying Wings | Restoration | 0 | September 18th 03 05:48 PM |
| Carbon Spar design and construction workshop | Marske Flying Wings | Home Built | 0 | September 18th 03 05:47 PM |
Linear Mode
