|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 18th 03, 05:48 PM
|
|||
|
|||
Carbon Spar design and construction workshop
The Marske Flying Wing Shop in Marion Ohio will conduct a Carbon Spar
design and construction workshop for composite aircraft on November 22 and 23 ,2003. Those interested should email us immediately. Cost will be $250 Jim Marske over the last ten years has developed wing spars utliizing carbon rods as in his design of the Genesis which with stood over 18 G's before the fixture broke. This is a very good chance to see how a spar should be built and as well as having the tools to design the spar you will actually take part in making a spar. -- -- Marske Flying Wings http://www.continuo.com/marske 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| amateur design consultant? | Shin Gou | Home Built | 14 | June 30th 04 01:34 AM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | May 1st 04 07:29 PM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 1 | January 2nd 04 09:02 PM |
| Marske spar workshop | Marske Flying Wings | Home Built | 0 | October 14th 03 04:53 PM |
| Carbon Spar design and construction workshop | Marske Flying Wings | Home Built | 0 | September 18th 03 05:47 PM |
Hybrid Mode
