![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
https://en.wikipedia.org/wiki/Bristol_Scout
The Bristol Scout was a single-seat rotary-engined biplane originally intended as a civilian racing aircraft. Like other similar fast, light aircraft of the period it was acquired by the RNAS and the RFC as a "scout", or fast reconnaissance type. It was one of the first single-seaters to be used as a fighter aircraft, although it was not possible to fit it with an effective forward-firing armament, until the first British synchronisation gears became available, by which time the Scout was obsolescent. Single-seat fighters continued to be called "scouts" in British usage into the early 1920s Role single-seat scout/fighter Manufacturer British and Colonial Aeroplane Company Designer Frank Barnwell First flight 23 February 1914 Primary users Royal Flying Corps Royal Naval Air Service Australian Flying Corps Produced 1914–1916 Number built 374 The design was an equal-span single-bay biplane with staggered parallel-chord wings with raked wingtips and ailerons fitted to the upper and lower wings, which were rigged with about half a degree of dihedral, making them look almost straight when viewed from the front. The wing section was one designed by Coanda, which had been used for the wings of the Bristol Coanda Biplanes.[3] The rectangular-section fuselage was an orthodox wire-braced wooden structure constructed from ash and spruce, with the forward section covered with aluminium sheeting and the rear section fabric covered. It was powered by an 80 hp (60 kW) Gnome Lambda rotary engine enclosed in a cowling that had no open frontal area, although the bottom was cut away to allow cooling air to get to the engine. It had a rectangular balanced rudder with no fixed fin and split elevators attached to a non-lifting horizontal stabiliser. The fixed horizontal tail surfaces were outlined in steel tube with wooden ribs and the elevators constructed entirely of steel tube. The period of service of the Bristol Scout (1914–1916) marked the genesis of the fighter aircraft as a distinct type and many of the earliest attempts to arm British tractor configuration aircraft with forward-firing guns were tested in action using Bristol Scouts. These began with the arming of the second Scout B, RFC number 648, with two rifles, one each side, aimed outwards and forwards to clear the propeller arc. Specifications (Bristol Scout D) General characteristics Crew: one Length: 20 ft 8 in (6.30 m) Wingspan: 24 ft 7 in (7.49 m) Height: 8 ft 6 in (2.59 m) Wing area: 198 ft² (18.40 m²) Empty weight: 789 lb (358 kg) Loaded weight: 1,195 lb (542 kg) Powerplant: 1 × Le Rhône 9C rotary piston engine, 80 hp (60 kW) Performance Maximum speed: 94 mph (151 km/h) Service ceiling: 16,000 ft (4,900 m) Rate of climb: 18 min 30 sec to 10,000 ft (18 min 30 sec to 3,048 m) Power/mass: 0.067 hp/lb (0.11 kW/kg) Combat endurance: 2½ hours * |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
FREE Sky Scout | [email protected] | Soaring | 1 | August 25th 12 03:07 PM |
R/C Flying - Bristol scout.jpg (1/1) | Mitchell Holman[_2_] | Aviation Photos | 0 | July 2nd 08 12:54 PM |
Wings, Wires, and Watercolors - Bristol Scout 1913-14.jpg (1/1) | Mitchell Holman[_2_] | Aviation Photos | 0 | March 1st 07 04:14 AM |
looking for a Scout (tug) | One9er | Soaring | 3 | December 22nd 03 06:05 PM |
Slightly OT Boy Scout Needs Help | Pete Pemberton | Piloting | 2 | August 12th 03 05:02 PM |