![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Please tell me what kind of regulator should be used with
the Nelson A-4 Flow Meter - constant flow system - ? And does anyone have one for sale ? Please advise - thanks in advance - Ralph Woodward |
|
#2
|
|||
|
|||
|
On Tuesday, January 16, 2018 at 12:56:07 PM UTC-7, wrote:
Please tell me what kind of regulator should be used with the Nelson A-4 Flow Meter - constant flow system - ? And does anyone have one for sale ? Please advise - thanks in advance - Ralph Woodward And please tell me if anyone has the Oxymizer Cannula for sale ? |
|
#3
|
|||
|
|||
|
Ralph- Most any constant flow regulator will work with the Nelson A4 flowmeter (now produced and sold by Mountain High as the MH4). Pressure delivered is not much of a factor, as long as tubing on the inlet side of the flowmeter is clamped tightly enough to hold against whatever pressure the regulator delivers. I have seen some regulators that have an outlet pressure over 100 psi. Mountain High regulators are normally around 15 psi. I have both in stock. Contact me at: info at mmfabrication dot com
|
|
#4
|
|||
|
|||
|
Craggy Aero
Has both regulators and Oxymizer cannulas in stock. http://www.craggyaero.com/xcr_systems1.htm Richard www.craggyaero.com |
|
#5
|
|||
|
|||
|
One comment - Absolutely go with using the oxymizer cannula. According to some of my reading you can save 2x to 4x of your O2. Take a look at the two different flow scales on the MH-4 (http://www.mhoxygen.com/portable-con...h4-flowmeters-) The long right hand scale is for a standard cannula and the much shorter right hand scale is for the oxymizer.
|
|
#6
|
|||
|
|||
|
Sorry, of course I should have said, "The long right hand scale is for a standard cannula and the much shorter left hand scale is for the oxymizer."
|
|
#7
|
|||
|
|||
|
I have an Aerox constant flow regulator, with needle valve, pressure gauge, Nelson flowmeter, and moustache style cannula. The regulator is set up with a 4' high pressure inlet line so it can be mounted remote from the O2 bottle. Fits standard Schleicher factory bottle. That setup allows the pilot to reach & adjust the needle valve (which controls flow rate) in flight. It was used lightly as a temporary/removable system in ASW-27/29.
Will trade even and deliver for a good steak dinner & bottle of wine at Reno Convention. Email: Royb - AT - bourgeoiswhite.com ROY |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trying to locate David Nelson of Nelson Sailplane Services | PS | Soaring | 2 | September 17th 09 06:07 PM |
| water meters | Roy Bourgeois | Soaring | 17 | September 5th 07 10:52 PM |
| Digital meters 3 | [email protected] | Home Built | 10 | April 25th 06 07:30 AM |
| About digital meters | [email protected] | Home Built | 9 | April 17th 06 05:18 AM |
| G-Meters | Paul Remde | Soaring | 17 | October 10th 05 04:50 PM |