![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I'm in a situation where I need to elevate my Flarm antenna above the glare shield to avoid interference directly ahead of the glider(LAK17AT) due to the carbon nose cone. I'm getting a pretty nasty blind spot there.
I've seen installations where the Flarm antenna was elevated using a "paint stir stick" that was attached to the side of the glare shield. Essentially, that put the antenna on a mast. Two questions to the hive - 1) Has anyone seen a more elegant solution? 2) Does the Transponder antenna need to be elevated too? (That seems to get good reception in it's current location on the side of the glare shield.) Thanks in advance for any advice! Lou |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Flarm antenna mounting in a K6 | Rob Shepherd | Soaring | 0 | March 16th 19 05:22 PM |
flarm antenna placement | Matt Herron Jr. | Soaring | 3 | July 14th 18 05:00 AM |
FLARM antenna mounts for ASG-29 | Sean F (F2) | Soaring | 20 | September 11th 13 02:35 PM |
Again with FLARM antenna questions. | brianDG303[_2_] | Soaring | 0 | July 23rd 12 05:35 PM |
FLARM antenna installation | Kevin Neave | Soaring | 5 | January 16th 07 06:53 PM |