|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 18th 21, 06:47 PM
posted to rec.aviation.soaring
|
|||
|
|||
polyurethane finishes
Hi all,
I just purchased a glider with a factory PU finish. I'd like to know more about them, including: - best practices for maintenance - failure modes - method for repairing minor dings etc. - causes of wear and tear I am pretty familiar with gelcoat but know very little about PU. Thanks, Matt 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sailplane Finishes | Buba Smith | Soaring | 7 | December 27th 11 04:40 PM |
| UK Contest Finishes | johngalloway[_2_] | Soaring | 1 | September 1st 11 03:28 AM |
| Polyurethane finish? | Uniform Zulu | Soaring | 5 | February 7th 08 08:32 AM |
| competition finishes | Derek Ruddock | Soaring | 7 | February 13th 07 02:00 PM |
| GP finishes | bagmaker | Soaring | 0 | May 25th 06 01:11 AM |
Threaded Mode