![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Where is a good place to buy a replacement JPI EGT probe? It looks like
JPI wants $300 directly, is there a better outlet? -Robert |
#2
|
|||
|
|||
![]()
So in addition to the other 4786 reasons not to buy JPI their
replacement probes cost 300 clams? That can't be right. My EI probes cost $60 each. Robert M. Gary wrote: Where is a good place to buy a replacement JPI EGT probe? It looks like JPI wants $300 directly, is there a better outlet? -Robert |
#3
|
|||
|
|||
![]()
I was wrong. The JPI probe is $61 from JPI. I have to say that one bad
probe in 5 years isn't bad. Plus I love the FF integration. |
#4
|
|||
|
|||
![]()
Too bad you have JPI. I had one go bad in our EI analyzer and they sent
me one for free.... I just called them up and they dropped one in the mail. Now that is service!! :-) Jon Kraus '79 Mooney 201 4443H @ TYQ Robert M. Gary wrote: Where is a good place to buy a replacement JPI EGT probe? It looks like JPI wants $300 directly, is there a better outlet? -Robert |
#5
|
|||
|
|||
![]()
There are two probe types available for EGT use and they aren't
manufacturer specific. Most are 'K' type. Find a good used probe and install it. If you got to have new, give most of the typical suppliers like Spruce and Chief a call and they can fix you up. No need to buy from JPI, they all do the same thing. Cheers Dave Jon Kraus wrote: Too bad you have JPI. I had one go bad in our EI analyzer and they sent me one for free.... I just called them up and they dropped one in the mail. Now that is service!! :-) Jon Kraus '79 Mooney 201 4443H @ TYQ Robert M. Gary wrote: Where is a good place to buy a replacement JPI EGT probe? It looks like JPI wants $300 directly, is there a better outlet? -Robert |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cobra Trailer Axel Replacement | Carter | Soaring | 7 | July 7th 04 02:06 PM |
TE probe for SGS2-33 | Rod Pool | Soaring | 1 | May 20th 04 06:08 PM |
Cleaning a 3-way TE probe | Jack Glendening | Soaring | 37 | November 5th 03 06:45 PM |
TKM MX-11 Com true slide replacement ? | Rohit Fedane | Owning | 0 | September 21st 03 05:02 PM |
Broken line to Oil Temperature Probe, Repairable? | rkane33 | Owning | 2 | July 25th 03 03:19 AM |