|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 21st 05, 11:28 PM
posted to rec.aviation.ifr
|
|||
|
|||
Low battery voltage level
Hi All,
I'm looking for recommendations for a low battery warning voltage level. I was going to use 12.8V - is this liable to be triggered by noise/dips in the bus voltage? My guess is when heaters or motors kick in there could be a momentary drop due to high current that could trigger my low voltage indicator. Also it it worth putting a long time constant filter on this? Thanks! Mark. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Low voltage warning level | markp | Home Built | 1 | December 27th 05 05:11 AM |
| Displaced AFSS "controllers" heading for BIL and GRB | Chip Jones | Instrument Flight Rules | 12 | April 10th 05 09:22 PM |
| Parachute fails to save SR-22 | Capt.Doug | Piloting | 72 | February 10th 05 05:14 AM |
| 14 Volt Gel Cell? | Joe Allbritten | Soaring | 32 | May 11th 04 01:37 AM |
| ICom A-5 Question - Battery Level Indicator | Harry Gordon | Piloting | 22 | December 5th 03 12:07 AM |
Threaded Mode