![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
How does the water sealing system on a Cobra normally work?
On the inside lower edge of each side there is a small trough. (A great place to store the TE probe, etc.) If I look closely, there are small high water marks in there. Also drain holes at the front and rear ends. (One of which was clogged.) From experiments with a hose outside, it looks like a little water is getting by the rubber trim piece/rub rail on the outside. Looks like a possible design was if water goes out faster than it goes in, all is well. Except there was a bit of carpet dipping down in the trough which wicked water up and over the side to the glider. So I'm wondering if anybody here has looked at how the seal system around the lower sides of the trailer top are supposed to be. I may have to rethink where the nice shiny TE probe is stored as well. |
#2
|
|||
|
|||
![]()
Condensation?
|
#3
|
|||
|
|||
![]()
Yes, condensation my first thought.
Drains clear is second. Yes, quite a few threads on here for replacing clam to base seals. Not to be a butthead (but I will be), search on replacing clam to base seals. Cheap, search. More expensive but easier, go to OEM support. |
#4
|
|||
|
|||
![]()
Thanks guys. Sounds like the trough+drains might be part of the plan for condensation, but that's not the source I'm seeing.
Also, the clam to bottom seal looks good and the leak is above it. I'm seeing water in the trough from a hose streaming water down the side of the trailer over the rub rail. Not sure if this part is supposed to leak or not. I can try Cobra, but I though I'd ask here first. |
#5
|
|||
|
|||
![]()
On Tuesday, December 18, 2018 at 9:05:19 AM UTC-8, wrote:
Thanks guys. Sounds like the trough+drains might be part of the plan for condensation, but that's not the source I'm seeing. Also, the clam to bottom seal looks good and the leak is above it. I'm seeing water in the trough from a hose streaming water down the side of the trailer over the rub rail. Not sure if this part is supposed to leak or not. I can try Cobra, but I though I'd ask here first. Try Ralf: rdiestertich?cobratrailer?com Replace the questionable bits with the usual. Jim |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Aluminum top Cobra trailers leaks - how frequent? | AK | Soaring | 2 | March 31st 10 11:05 PM |
Aluminum top Cobra trailer leaks - how frequent? | AK | Soaring | 9 | March 30th 10 12:44 AM |
Oil leaks? | John Doe | Owning | 5 | February 4th 06 05:42 PM |
finally go fly and now we freeze (172 air leaks) | Mike Z. | Owning | 11 | December 11th 03 05:22 PM |
Observations about oil leaks | Ben Jackson | Owning | 5 | October 9th 03 11:03 PM |