![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
|
|||
|
|||
|
Hi BJ;
Hope all is well with you these days. Yes; you are correct about that John. I haven't talked with the new guys, as my association with the team involves us "older" folks :-)) but the procedure in both the official TB regulations for the team and the preflight brief as far as I know haven't been changed through the years from using the field elevation at the show sites as a MSL reference for both the Diamond and solo maneuver target altitudes. The trick is remembering the targets! What happens is very subtle and could bite anyone as it bit Stricklin. When you practice day after day at the same location as the team does at Indian Springs near Nellis, your subconscious can store this repetitious data as a constant. Then you go to another location and fly a demonstration there. You go through a normal brief and note the target properly as being different naturally, because of the difference in field elevations between the two points. Then you enter the front side of the maneuver knowing full well the briefed top target and then something happens....a slight distraction.....doesn't have to be much.....something breaks that intense concentration you have going up....then suddenly the distraction's vanished and you snap back immediately. Your eye catches the altimeter at exactly the altitude your subconscious has stored and you react instinctively and initiate the reverse. Nothing else is out of place and you haven't picked it up yet as even a possible error. The result of this is that you miss the visual cues as well that should be telling you you're a full thousand feet lower in the reverse than you should be. Your airspeed is in the energy gate parameters so absolutely nothing is caught that should be screaming at you to exit out in roll and call a maneuver miss. Once you commit past the inverted gate, you're dead already. This is exactly what happed to Strickin. He had a brain fart on the frontside and missed every cue that he should have caught. The team is looking hard at the broken concentration issue. but I doubt if the procedure for using field elevation for maneuver targets will change. The final result will probably be a "head's up" official report stressing the need for unbroken concentration at all times by all team members. Also, in all preflight briefs, it's common practice to have each team member answer a safety question given by the boss. I'm fairly certain that just before the usual compulsory in cadence hand slapping on the desktops begins, this "head's up" on concentration will be a required reminder by the boss to each position. I'm looking for this is ALL teams as well...throughout the world, as with something like this....EVERYBODY learns!! Dudley "Big John" wrote in message ... Welcome back Dudley. Do the Leader and Solo T-birds use 'crib' sheets showing the maneuvers with entry airspeed and altitude normalized for field where they are performing? If not, that might be a 'cheap' and easy safety procedure. See where next years team was formalized and have started working together. And a nice day to thee. BJ Pilot ROCAF On Mon, 08 Mar 2004 17:37:29 GMT, "Dudley Henriques" wrote: "David Brooks" wrote in message ... "BTIZ" wrote in message news:srO2c.16250$id3.4338@fed1read01... ok.. I may be backwards... I don't normally define the use of Q settings.. The bottom line is, the discussion was brought up with the AF T-Bird doing acro and not computing the altitude needed at the top of a maneuver to safely pull out above ground level. Some argue to set the altimeter to zero elevation before takeoff. It just can't be done in many places out west. IIRC, this discussion earlier revealed that the T-bird pilots have super-wizzo-thingummy altimeters that can indeed set QFE at high elevations. Granted, yours and mine can't. -- David Brooks Hi David; The Thunderbirds use a standard altimeter setting for the point of demonstration and do not use a 0 altimeter set. Their maneuver profiles are corrected to MSL altitudes. Stricklin unfortunately on the way up the front side of his maneuver mentally "corrected" his reverse top target gate to Nellis' elevation instead of where he was. This put the Viper way low of where it should have been at the top side commit. He missed his visual cues as well. The airplane simply didn't have the g available vs the altitude under it to cut the corner. Dudley |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Setting Up An Airport Trust Fund? | Jay Honeck | Piloting | 4 | February 24th 04 11:54 PM |
| low altimeter and FL180 | Michael 182 | Piloting | 26 | October 31st 03 05:29 AM |
| KAP140 Autopilot Details | News | Instrument Flight Rules | 27 | October 22nd 03 03:01 AM |
| Prop bolt torque setting | Whunicut | Home Built | 2 | September 4th 03 01:12 PM |
| WOT in cruise? | Roger Long | Owning | 10 | July 28th 03 09:00 AM |