![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]() Hi I'm running in my overhauled engine - 4 hrs - all a full rich. Today I landed at a nearby airport and when I did the run-up to return home the left mag gave a 400 rpm drop. I tried it again and got another 400 pm drop. Third time I tried it I had no left mag at all - drop to cut-off - same 4th time. Shut down - check all connections - everything looked good - no loose wires etc. Today for the first time I used my new carb-temp guage and as it was reading 30F I added a small amout of carb heat to bring it to 37F. On reflection I should have leaned slightly to allow for the extra richness from the cab heat but I didn't. I went back to the aircraft and it stated OK. I ran it leaned for a couple of minutes, went full rich to 1700 rpm and did mag checks - both were good. I did it 5 times, and departed for home. Aircraft ran great, after landing I did 3 more mag checks and they were all good. Question - Could fouling really have totally shut down my left mag? Thanks for reading, Tony -- Tony Roberts PP-ASEL VFR OTT Night Cessna 172H C-GICE |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Does anyone have Kitplanes Mag's from 1986? | Nunya | Home Built | 10 | June 21st 11 07:22 AM |
VW1834 and Slick 4001 Mags | M J Veary | Home Built | 4 | March 4th 05 11:23 PM |
FA: Slick Mags (used) 600 series with harness | BFC | Aviation Marketplace | 0 | June 24th 04 04:21 PM |
Two Mags from Florida | Larry Smith | Home Built | 7 | October 25th 03 08:47 AM |
Av mags and sims.... | Don Parker | Simulators | 7 | August 11th 03 05:48 PM |