![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
My Becker radio stopped working recently and I'm trying to determine
what to do next. It transmits a carrier tone when the mic is keyed, but no voice. Any speculation on what is most likely the problem? The wires that go from the mic to the D connector on the back of the radio test positive for continuity. I assume the Becker USA office in Florida is the best place to have it sent, if necessary? -ted/2NO |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dittel Radio Repair | [email protected] | Soaring | 4 | July 22nd 05 12:02 PM |
I Hate Radios | Ron Wanttaja | Home Built | 9 | June 6th 05 05:39 PM |
Calibrate? Repair? Adjust? | RST Engineering | Owning | 3 | April 4th 05 01:41 PM |
Becker Radio battery | John Giddy | Soaring | 3 | October 20th 04 07:52 PM |
radio repair | Raphael Warshaw | Soaring | 0 | June 22nd 04 07:57 PM |