|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 21st 03, 03:56 AM
|
|||
|
|||
NACO chart question
In my limited IFR flying.. I have always used Jepp charts. (They seemed much
easier to read and use) The cost difference and their availability on the web has caused me to seriously considered switching to NACO. After reviewing these again (NACO) they seem much improved over the old days... however, I cannot find the departure procedures for the non SID airports, Jepp always printed it on the approach plates....where to look? or are they listed differently? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A question on Airworthiness Inspection | Dave S | Home Built | 1 | August 10th 04 05:07 AM |
| Question | Charles S | Home Built | 4 | April 5th 04 09:10 PM |
| Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 01:51 AM |
| Question about Question 4488 | [email protected] | Instrument Flight Rules | 3 | October 27th 03 01:26 AM |
| NACO charts - why have a reference circle? | Bob Gardner | Instrument Flight Rules | 5 | September 6th 03 01:15 PM |
Threaded Mode