|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#17
February 29th 04, 06:42 AM
|
|||
|
|||
"Gord Beaman" wrote in message ... Rich Ahrens wrote: Matthew S. Whiting wrote: JL Grasso wrote: On Thu, 26 Feb 2004 19:25:26 -0800, "Tarver Engineering" wrote: The whole point of using a static port is to be able to take the guts out of a pitot tube and produce only pitot pressure, thus increasing the reliability of the system. Bwaaaaahwahwahwahwahwahwahwahwah3wahw! Jerry Yes, those static ports are pretty unreliable! :-) All those moving parts... Can you just imagine how long the tech course must be?... -- -Gord. No doubt the "Delicate Complicated Electronics" involved would require a "Senior EE" to supervise/oversee their design for the best interest of all. Ralph Nesbitt Professional FD/CFR/ARFF Type 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode