|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#29
January 4th 06, 03:49 PM
posted to rec.crafts.metalworking,rec.autos.tech,rec.aviation.homebuilt
|
|||
|
|||
see four-point sockets
Roger wrote: On 3 Jan 2006 11:39:10 -0800, wrote: four point (square) sockets (and/or wrenches) who makes them, who retails 'em? Who on an aviation group uses "FARMER BOLTS" :-)) I've never see a 4-pt socket, but open end wrences work well. Usually the bolt is of such quality you can plan on twisting it off rather then getting the nut off. Good luck, Roger Halstead (K8RI & ARRL life member) (N833R, S# CD-2 Worlds oldest Debonair) www.rogerhalstead.com I don't know about more modern cars, but on my old Studebakers there's quite a few pipe plugs that have square heads. nate 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adding a lifting point. | [email protected] | Home Built | 1 | March 8th 05 04:05 PM |
| A Question For Real Airline Pilots | Blue | Simulators | 34 | September 6th 04 02:55 AM |
| flight training - 100nm night flight requirement | Jonathan | Piloting | 36 | May 11th 04 08:34 PM |
| How fast should an ADF point? | Ben Jackson | Instrument Flight Rules | 6 | November 21st 03 04:50 AM |
| Reaming needed on aft wing attach point. | Boelkowj | Home Built | 0 | November 7th 03 02:30 AM |
Threaded Mode