|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 30th 04, 02:36 PM
|
|||
|
|||
Vacuum pressure
At what rpm do people see their vacuum pressure drop below an acceptable
level(3.2?). I also have a standby vac with a low vac pressure red warning light. When I reduce power to 1200-1300 rpm the vac pressure drops off and the red light comes on. I thought in the past the pressure would hold until around 1000 rpm. Does this seem to be working properly? TIA, Pete 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wet vs Dry Vacuum Pump | Fastglasair | Home Built | 1 | December 15th 04 05:17 PM |
| Attn: Hydraulic experts - oil pressure relief fix? | MikeremlaP | Home Built | 7 | November 6th 04 08:34 PM |
| Attn: Hydraulic experts - oil pressure relief fix? | MikeremlaP | Home Built | 0 | November 2nd 04 05:49 PM |
| Vacuum "pressure" for gyros | Jari Kaija | Home Built | 3 | March 18th 04 05:08 PM |
| Pressure Differential in heat Exchangers | Bruce A. Frank | Home Built | 4 | July 3rd 03 05:18 AM |
Threaded Mode