![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
On 06/16/06 09:23, Steven P. McNicoll wrote:
"Mark Hansen" wrote in message ... When told to head direct EXECC (IAF) and fly the approach pilot-nav. Technically, EXECC is the IAF, not the VOR. However, because they are so close, I think most pilots just use the VOR. There's a feeder route from the VOR to EXECC. There's no need for ADF on this approach, the note "ADF REQUIRED" is an error. But the VOR is not an IAF and doesn't provide a NoPT route to EXECC, so when you get to EXECC you still need to execute the procedure turn. Do you agree that the procedure turn should be made about EXECC? When coming from the north, the pilot is going to have to make a u-turn at the VOR, then, while in the zone of confusion, follow the 018 degree radial to find the LOM... whew. Do you think we should be able to identify the fix for the PT using the marker beacons? A marker beacon receiver isn't required. What if the plane doesn't have one? I think the ADF receiver makes this scenario much simpler for the pilot, and that was the reason for requiring it to execute the approach. -- Mark Hansen, PP-ASEL, Instrument Airplane Cal Aggie Flying Farmers Sacramento, CA |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help! - Wooden prop - any info? | G0MRL | Aviation Marketplace | 1 | February 13th 06 03:14 PM |
Seeking Northrop Gamma info | Dillon | Restoration | 3 | December 12th 05 04:45 AM |
Helicopter Physics info online anywhere?? | [email protected] | Rotorcraft | 4 | April 24th 04 04:18 PM |
POSA Carb Info and HAPI Engine Info | Bill | Home Built | 0 | March 8th 04 08:23 PM |
Starting new info site need info from the pros | MRQB | Piloting | 7 | January 5th 04 03:20 AM |